Touch 2 with Go - manually switch to camera mode
Hi all,
I have a Toyota C-HR with Touch 2 with Go multimedia system.
I recently installed a 4 camera bird-view parking system on my C-HR. Works well when I put the gear shift in reverse R.
When I turn left or right, I use the indicators and the gear shift is on drive position D. In this case, the camera system is able to show me the curbs. But my Touch 2 with Go multimedia only enters camera mode when the gear shift is in R, not in D.
As you can see in the attached picture, on the 28-pin connector, pin no 2 should be for the Reverse Gear position. But my connector has no wire there. Is empty.
So, my question is:
How do I manually put my Touch 2 with Go in camera mode, without putting the gear shift in R? Does anyone know what signal or voltage and where I need to inject into my Touch 2 with Go to enter camera mode?
Thank you.
I have a Toyota C-HR with Touch 2 with Go multimedia system.
I recently installed a 4 camera bird-view parking system on my C-HR. Works well when I put the gear shift in reverse R.
When I turn left or right, I use the indicators and the gear shift is on drive position D. In this case, the camera system is able to show me the curbs. But my Touch 2 with Go multimedia only enters camera mode when the gear shift is in R, not in D.
As you can see in the attached picture, on the 28-pin connector, pin no 2 should be for the Reverse Gear position. But my connector has no wire there. Is empty.
So, my question is:
How do I manually put my Touch 2 with Go in camera mode, without putting the gear shift in R? Does anyone know what signal or voltage and where I need to inject into my Touch 2 with Go to enter camera mode?
Thank you.
