Toyota C-HR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi guys. The problem with my steering wheel is that whenever the signal is on and I try to turn the wheel, at specific angles I hear a clicking sound. I could hear 3 of them on each side to the end of twirl.
I brought the cat to Sevice Center and they said that it's a normal sound and every other car has the Same! feature! But the sound was not there when I bought it in the first place. And my previous Corolla didn't have the clicking sound!
Still, it's annoying to hear these clicking sounds while you're driving a new car!
Does any of you have the same experience? Any fix for this?
Best.
 

·
Registered
Joined
·
61 Posts
It should be there... It's the switch that touches the notch that will put the switch back to it's neutral position when steering back. It has always been there; i guess you didn't notice it beforehand (radio on?).
 
  • Like
Reactions: Mehrdad Fonouni

·
Registered
Joined
·
208 Posts
My 2 cents, and it may be completely unrelated, but I removed the bottom shroud on my steering wheel column to install my remote start. Afterwards, I began hearing an unusually noise when turning the wheel. It is still there and I suspect that I did not properly seat the cover when I reinstalled it. It is not a "clicking" noise, but more of a rubbing sound. Maybe yours wasn't properly installed at the factory?
 
1 - 3 of 3 Posts
Top