Toyota C-HR Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
352 Posts
Discussion Starter #1
Hey guys,

Just confirming, I've read through Jadehawk, Bilt, and other's posts, and kind of got the gist of it. But still, since everyone is using different things, I'm a little scared.

So what I have thus far:
Kenwood DMX7704S
idatalink Maestro RR

What I still need (?):
1. Metra 40-LX11 Antenna Adaptor Cable - Select 2009-Up Lexus/Toyota (To get radio reception)
2. iDatalink Maestro ADS-HRN-RR-TO1 TO1 Plug & Play T-Harness for Toyota Vehicles (bilt confirmed that maestro works with it now)
3. AXXESS AX-TOYUSB - USB-Auxilliary Retention Harness - USB adaptor to retain the OE USB in select Toyota vehicles (so the center console usb stays working)
4. Axxess AX-TOY28SWC Steering Wheel Controller Add-On Harness with RCA and 28-Pin Connector for Toyota Vehicles (from evilbass correspondence with maestro people.)
5. Wiring diagram on chr?

Am I missing anything?
 

·
Registered
Joined
·
352 Posts
Discussion Starter #2
Do I need the faceplate thing?

Metra 95-8265HG 2-Din Dash Kit for Select Toyota CH-R 2018-Up
by Metra
Link: http://a.co/6nCkMiF
 

·
Registered
Joined
·
410 Posts
Wish I could help you more, but this looks way too complicated since the parts are being purchased individually. You could always try contacting the radio manufacturer and ask them what you'd need for an installation.
 

·
Registered
Joined
·
352 Posts
Discussion Starter #5
Wish I could help you more, but this looks way too complicated since the parts are being purchased individually. You could always try contacting the radio manufacturer and ask them what you'd need for an installation.
Yeah.. thanks for tryin though! :crying:
 

·
Registered
Joined
·
99 Posts
Yes, the faceplate will be needed, but I only used the left and right brackets. I did not use the "ring" plate.
 
1 - 6 of 6 Posts
Top