Tried to evade what appears to have been a rubber road cone weight. It was six-sided? and had a hole in the middle. Kicked up by another vehicle and I did not had time to avoid it. Smacked into the passenger side lower bumper.
Thank goodness it was only to the plastic parts and not kicked up any higher.
Broke the washer fluid jug
Hopefully less than my deductible...
Replaced the water jug anyway. At least I could remove it easily. And it only cost $84 and my time.
Removed all parts from "jug" before removing the "jug" from the vehicle. except for the washer pump. the pump is easily removed and is held in by the frame of the jug and the gasket/filter. Good thing it has a filter.
Installed the gasket/filter in the replacement "jug"
There is a green marked hose that goes on the right of the pump motor. That way the fluid goes to the correct nozzle(s) - front or rear. Pointing to the "green" one in the photo below.
Will have the C-HR at the shop by Tuesday for the other repairs. I think that I lost some fasteners in the wheel cowl and definitely at the bumper cover and lower bumper area.
I found the black insert (where there is a hole now) intact inside when I got home. no damage to it at all and is re-usable.