To the one who is boring on the weekend, here's something cheap and EASY to DIY for you.
Here is the list of tools:
2.2X LED T10 lights.
I. Remove the panel in the photo 1
II. Take around 2X100cm wires, and connect them to the positive and negative of the LED (Photo 2)
III. Find the positive power source. I used the third pin(Blue) of the Auto High Beam switch (Photo 3 and 4)
IV. Connect the negative wire to photo 5.
V. Put the LED into the reserved hole. (Photo 6) And use the insulation tape to cover the Upper side to prevent the light from leaking.
Then put everything back on (passenger side is pretty much the same, only you might need a longer wire to run the positive wire to the driver side and plug it into the same power source), and you are good to go...!!!